5.0

19
The included effect plug-ins
Tremolo
Tremolo produces amplitude (volume) modulation.
Parameters are as follows:
Vibrato
The Vibrato plug-in produces pitch modulation.
Other plug-ins
This section contains descriptions of the plug-ins in the
“Others” category.
Bitcrusher
If you’re into lo-fi sound, Bitcrusher is the effect for you. It
offers the possibility of decimating and truncating the in-
put audio signal by bit reduction, to get a noisy, distorted
sound. You can for example make a 24-bit audio signal
sound like an 8 or 4-bit signal, or even render it completely
garbled and unrecognizable. The parameters are:
Parameter Description
Rate If tempo sync is on, this is where you specify the base
note value for tempo-syncing the effect (1/1 to 1/32,
straight, triplet or dotted).
If tempo sync is off, the modulation speed can be set
freely with the Rate knob, without sync to tempo.
Tempo sync
on/off
The button below the Rate knob is used to switch tempo
sync on or off. The button is lit when tempo sync is on.
Depth This governs the depth of the amplitude modulation.
Spatial This will add a stereo effect to the modulation.
Output Adjusts the output volume.
Parameter Description
Rate If tempo sync is on, this is where you specify the base
note value for tempo-syncing the effect (1/1 to 1/32,
straight, triplet or dotted).
If tempo sync is off, the modulation speed can be set
freely with the Rate knob, without sync to tempo.
Tempo sync
on/off
The button below the Rate knob is used to switch tempo
sync on or off. The button is lit when tempo sync is on.
Depth This governs the depth of the pitch modulation.
Spatial This will add a stereo effect to the modulation.
Parameter Description
Mode Select one of four operating modes for the Bitcrusher.
Each mode will produce a result sounding a bit different.
Modes I and III are nastier and noisier, while modes II and
IV are more subtle.
Sample Divider This sets the amount by which the audio samples are
decimated. At the highest setting (65), nearly all of the in-
formation describing the original audio signal will be elim-
inated, turning the signal into unrecognizable noise.
Depth Use this to set the desired bit resolution. A setting of 24
gives the highest audio quality, while a setting of 1 will
create mostly noise.
Output Governs the output level from the Bitcrusher. Drag the
slider upwards to increase the level.
Mix This slider regulates the balance between the output from
the Bitcrusher and the original audio signal. Drag the slider
upwards for a more dominant effect, and drag it down-
wards if you want the original signal to be more prominent.