5.0

15
The included effect plug-ins
Chorus
This is a single stage chorus effect. It works by doubling
whatever is sent into it with a slightly detuned version.
The parameters are as follows:
Flanger
Flanger is a classic flanger effect with added stereo
enhancement.
The parameters are as follows:
Parameter Description
Tempo sync
on/off
The button below the Rate knob is used to switch tempo
sync on or off. The button is lit when tempo sync is on.
Rate If tempo sync is on, this is where you specify the base
note value for tempo syncing the chorus sweep (1/1 to
1/32, straight, triplet or dotted).
If tempo sync is off, the sweep rate can be set freely with
the Rate knob, without sync to tempo.
Width This determines the depth of the chorus effect. Higher
settings produce a more pronounced effect.
Spatial This sets the stereo width of the effect. Turn clockwise
for a wider stereo effect.
Mix Sets the level balance between the dry signal and the ef-
fect. If Chorus is used as a send effect, this should be set
to maximum as you can control the dry/effect balance
with the send.
Delay This parameter affects the frequency range of the modu-
lation sweep, by adjusting the initial delay time.
Shape This changes the shape of the modulating waveform, al-
tering the character of the chorus sweep. Sine and trian-
gle waveforms are available.
Filter Lo/Hi These parameters allow you to roll off low and high fre-
quencies of the effect signal, respectively.
Parameter Description
Tempo sync
on/off
The button below the Rate knob is used to switch tempo
sync on or off. The button is lit when tempo sync is on.
Rate If tempo sync is on, this is where you specify the base
note value for tempo syncing the flanger sweep (1/1 to
1/32, straight, triplet or dotted).
If tempo sync is off, the sweep rate can be set freely with
the Rate knob, without sync to tempo.
Range Lo/Hi This sets the frequency boundaries for the flanger sweep.
Feedback This determines the character of the flanger effect. Higher
settings produce a more “metallic” sounding sweep.
Spatial This sets the stereo width of the effect. Turn clockwise
for a wider stereo effect.
Mix Sets the level balance between the dry signal and the ef-
fect. If the Flanger is used as a send effect, this should be
set to maximum as you can control the dry/effect balance
with the send.
Shape This changes the shape of the modulating waveform, al-
tering the character of the flanger sweep.
Delay This parameter affects the frequency range of the modu-
lation sweep, by adjusting the initial delay time.
Manual If this is activated, the flanger sweep will be static, i.e. no
modulation. You can instead change the sweep position
manually by turning this knob.
Filter Lo/Hi These parameters allow you to roll off low and high fre-
quencies of the effect signal, respectively.