5.0

14
The included effect plug-ins
WahWah
WahWah is a variable slope band pass filter that can be
auto-controlled via MIDI modeling the well-known analog
pedal effect (see below). You can independently specify
the frequency, width and the gain for the Lo and Hi Pedal
positions. The crossover point between the Lo and Hi
Pedal positions is at 50.
The parameters are as follows:
MIDI control
For real-time MIDI control of the Pedal parameter, MIDI
must be directed to the WahWah plug-in.
• Whenever the WahWah has been added as an insert
effect (for an audio track or an FX channel), it will be avail-
able on the Output Routing pop-up menu for MIDI tracks.
If WahWah is selected on the Output Routing menu, MIDI will be directed
to the plug-in from the selected track.
Modulation plug-ins
This section contains descriptions of the plug-ins in the
“Modulation” category.
AutoPan
This is a simple autopan effect. It can use different wave-
forms to modulate the left-right stereo position (pan), either
using tempo sync or manual modulation speed settings.
The parameters are as follows:
Parameter Description
Pedal This controls the filter frequency sweep.
Freq Lo/Hi Sets the frequency of the filter for the Lo and Hi Pedal
positions.
Width Lo/Hi Sets the width (resonance) of the filter for the Lo and Hi
Pedal positions.
Gain Lo/Hi Sets the gain of the filter for the Lo and Hi Pedal positions.
Filter Slope Specifies the slope of the filter; 6dB or 12dB.
Parameter Description
Rate If tempo sync is on, this is where you specify the base
note value for tempo-syncing the effect (1/1 to 1/32,
straight, triplet or dotted).
If tempo sync is off, the auto-pan speed can be set freely
with the Rate knob, without sync to tempo.
Tempo sync
on/off
The button below the Rate knob is used to switch tempo
sync on (the button lights up) or off.
Width Sets the depth of the AutoPan effect.
Shape Sets the modulation waveform. Sine and Triangle wave-
forms are available.
Side-Chain
on/off
A signal routed to the Side-Chain input of the effect can
control the Width parameter when this is activated. For a
description of how to set up Side-Chain routing, see the
chapter “Audio effects” in the Operation Manual.