5.0

14
Menu Reference
Transport menu
Transport Panel
This opens the Transport panel.
Locators to Selection
This will set the locators to encompass the current selec-
tion or selection range.
Locate Selection
This moves the project cursor to the start of the current
selection or selection range.
Locate Selection End
This moves the project cursor to the end of the current se-
lection or selection range.
Locate Next Marker
This moves the project cursor to the next marker position.
Locate Previous Marker
This moves the project cursor to the previous marker posi-
tion.
Locate Next Event
This moves the project cursor to the next event start or
end on the selected track.
Locate Previous Event
This moves the project cursor to the previous event start
or end on the selected track.
Play from Selection Start/End
This activates playback from the beginning or end of the
current selection.
Play until Selection Start/End
This activates playback two seconds before the start or
end of the current selection and stops at the selection
start or end, respectively.
Play until Next Marker
This will activate playback from the current project cursor
position to the next marker and stop.
Play Selection Range
This will play back the current selection range and stop at
the end.
Loop Selection
This will loop playback of the current selection range.
Use Pre-roll
When this is activated and you start playback or record-
ing, Cubase AI will “roll back” a bit before starting.
Use Post-roll
When this is activated, Cubase AI will play back a short
section after automatic punch-out.
Start Record at Left Locator
If this is activated, the project cursor will jump to the left
locator position and begin recording when you hit the
Record button. If this is off (unticked), recording will start
directly from the current project cursor position.
Metronome Setup…
Opens the Metronome Setup dialog where you can make
various metronome settings.
Metronome On
Activates the metronome.
Precount On
Activates precount – a count-in that will be heard when
you start recording from stop mode and the metronome is
activated. This can also be activated on the Transport
panel. You can specify the number of precount bars in the
Metronome Setup dialog.
Project Synchronization Setup…
Opens a dialog where settings relating to synchronization
can be made.