4.0

25
The included effect plug-ins
Vibrato
The Vibrato plug-in produces pitch modulation.
Other plug-ins
This section contains descriptions of the plug-ins in the
“Others” category.
Octaver
This plug-in can generate two additional voices that track
the pitch of the input signal one octave and two octaves
below the original pitch, respectively. Octaver is best used
with monophonic signals. The parameters are as follows:
Tuner
This is a guitar tuner. Simply connect a guitar or other in-
strument to an audio input and select the Tuner as an in-
sert effect (make sure you deactivate any other effect that
alters pitch, like chorus or vibrato). When the instrument is
connected, proceed as follows:
• Play a note.
The key is shown in the middle of the display. In addition, the frequency in
Hz is shown in the bottom left corner and the octave range in the bottom
right corner. If the key is wrong (e.g. if you wish to tune the E string and the
key is shown as Fb), first tune the string so that the correct key is shown.
• The two arrows indicate any deviation in pitch by their
position. If the pitch is flat, they will be positioned in the
left half of the display, if the pitch is sharp they will be in
the right half.
The deviation is also shown (in Cent) in the upper area of the display.
• Tune the instrument so that the two arrows are in the
middle.
Repeat this procedure for each string.
Parameter Description
Tempo sync on/
off
The button below the Rate knob is used to switch tempo
sync on or off. The button is lit when tempo sync is on.
Rate If tempo sync is on, this is where you specify the base
note value for tempo-syncing the effect (1/1 to 1/32,
straight, triplet or dotted).
If tempo sync is off, the modulation speed can be set
freely with the Rate knob, without sync to tempo.
Depth This governs the depth of the pitch modulation.
Spatial This will add a stereo effect to the modulation.
Parameter Description
Direct This adjusts the mix of the original signal and the gener-
ated voice(s). A value of 0 means only the generated and
transposed signal is heard. By raising this value, more of
the original signal is heard.
Octave 1 This adjust the level of the generated signal one octave
below the original pitch. Set to 0 means the voice is
muted.
Octave 2 This adjust the level of the generated signal two octaves
below the original pitch. Set to 0 means the voice is
muted.
Parameter Description