4.0

23
The included effect plug-ins
Modulation plug-ins
This section contains descriptions of the plug-ins in the
“Modulation” category.
Flanger
Flanger is a classic flanger effect with added stereo en-
hancement.
The parameters are as follows:
Phaser
Phaser produces the well-known “swooshing” phasing ef-
fect with additional stereo enhancement.
The parameters are as follows:
Parameter Description
Tempo sync on/
off
The button below the Rate knob is used to switch tempo
sync on or off. The button is lit when tempo sync is on.
Rate If tempo sync is on, this is where you specify the base
note value for tempo syncing the flanger sweep (1/1 to
1/32, straight, triplet or dotted).
If tempo sync is off, the sweep rate can be set freely with
the Rate knob, without sync to tempo.
Range Lo/Hi This sets the frequency boundaries for the flanger sweep.
Feedback This determines the character of the flanger effect.
Higher settings produce a more “metallic” sounding
sweep.
Spatial This sets the stereo width of the effect. Turn clockwise
for a wider stereo effect.
Mix Sets the level balance between the dry signal and the ef-
fect. If the Flanger is used as a send effect, this should be
set to maximum as you can control the dry/effect balance
with the send.
Shape This changes the shape of the modulating waveform, al-
tering the character of the flanger sweep.
Delay This parameter affects the frequency range of the modu-
lation sweep, by adjusting the initial delay time.
Manual If this is activated, the flanger sweep will be static, i.e. no
modulation. You can instead change the sweep position
manually by turning this knob.
Filter Lo/Hi These parameters allow you to roll off low and high fre-
quencies of the effect signal, respectively.
Parameter Description
Tempo sync on/
off
The button below the Rate knob is used to switch tempo
sync on or off. The button is lit when tempo sync is on.
Rate If tempo sync is on, this is where you specify the base
note value for tempo syncing the phaser sweep (1/1 to
1/32, straight, triplet or dotted).
If tempo sync is off, the sweep rate can be set freely with
the Rate knob, without sync to tempo.
Width The width of the modulation effect between higher and
lower frequencies.
Feedback This determines the character of the phaser effect.
Higher settings produce a more pronounced effect.
Spatial When using multi-channel audio, Spatial creates a 3-di-
mensional impression by delaying modulation in each
channel.
Mix Sets the level balance between the dry signal and the ef-
fect. If the Phaser is used as a send effect, this should be
set to maximum as you can control the dry/effect balance
with the send.
Manual If this is activated, the phaser sweep will be static, i.e. no
modulation. You can instead change the sweep position
manually by turning this knob.
Filter Lo/Hi These parameters allow you to roll off low and high fre-
quencies of the effect signal, respectively.