12.0

● To change the length of the selected MIDI events or all events of the active part if
no events are selected, use the Scale Length/Scale Legato slider.
At the maximum value the notes reach the beginning of the next note.
● To make the new length settings permanent, click Freeze MIDI Lengths.
● To ne-tune the distance between consecutive notes, use the Overlap slider.
At 0 Ticks, the Scale Length/Scale Legato slider extends each note so that it
reaches the next note exactly. Positive values cause the notes to overlap and
negative values allow you to
dene a small gap between the notes.
● To use the Legato function or slider to extend a note until the next selected note,
activate
Extend to Next Selected.
This is identical with activating the Legato Mode: Between Selected Notes Only
option in the Preferences dialog.
Set up Inspector
Allows you to open a dialog to edit the Inspector settings for the editor. Click Set up
Inspector, and from the pop-up menu, select Setup.
NOTE
If you open the Key Editor in the lower zone, these sections are shown in the Editor Inspector in
the left zone.
RELATED LINKS
Quantize Panel on page 236
Opening the Editor Inspector on page 50
Note Display
The note display is the main zone in the Key Editor. It contains a grid in which note events are
shown as boxes.
The width of a box corresponds to the note length. The vertical position of a box corresponds to
the note number (pitch), with higher note events higher up in the grid.
MIDI Editors
Key Editor
585
Cubase AI 12.0.20