12.0

ManualsBrandsSteinberg ManualsApplicationsCubase AI

521

522

523

524

525

526

527

528

529

530

Table Of Contents

NOTE

You can make independent settings for the two Range sections.

AFTER COMPLETING THIS TASK

To deactivate the function, open the Range Target pop-up menu and select Off.

Range Modes

On the Range Target pop-up menu, you can select different range modes. Values are shown as

numbers, from 0 to 127, for the velocity modes and as note numbers, from C-2 to G8, for the

pitch modes.

Vel.Limit

Allows you to force all velocity values to t within the range that you specify with the

min and max values. Values below the lower limit are set to the min value, velocity

values above the higher setting are set to the max value.

Vel.Filter

Allows you to lter out notes with velocity values below the min value or above the

max value.

Note Limit

Allows you to transpose all notes below the min value upwards and all notes above the

max value downwards in octave steps.

Note Filter

Allows you to lter out notes that are lower than the min value or higher than the max

value.

Freezing MIDI Modiers

You can apply all lter settings permanently to the selected track. The settings are applied to the

events on the track, and all modiers are set to zero.

PROCEDURE

1. Select the MIDI track.

2. Select MIDI> Freeze MIDI Modiers.

RESULT

The following settings are frozen:

●

Several settings in the top section of the Inspector, such as Delay, Program Selector, and

Bank Selector.

●

The settings in the MIDI Modiers section, such as Transpose, Vel.Shift, Vel.Comp., and

Len.Comp..

●

The info line settings Transpose and Velocity.