12.0

Table Of Contents

If you activate Playback Toggle Triggers Local Preview in the Preferences dialog

(Transport page), you can use Space to audition. This is the same as activating Audition on

the toolbar.

● Select a clip and activate Audition.

The whole clip plays back. To stop playback, click Audition again.

● Click in the waveform image for a clip.

The clip plays back from the selected position in the waveform until the end. To stop

playback, click Audition or anywhere else in the Pool window.

The audio is routed directly to the Main Mix (the default output) bus, bypassing the settings of

the audio channel, effects, and EQs.

NOTE

You can adjust the auditioning level with the miniature level fader on the toolbar. This does not

affect the regular playback level.

If you have activated Audition Loop before you audition, the following happens:

●

When you click Audition to audition a clip, the clip is repeated indenitely until you stop

playback by clicking

Audition or Audition Loop again.

● When you click in the waveform image to audition, the section from the selected point to the

end of the clip is repeated indenitely until you stop playback.

Opening Clips in the Sample Editor

The Sample Editor allows you to perform detailed editing on the clip.

● To open a clip in the Sample Editor, double-click a clip waveform icon in the Media column.

● To open a certain region of a clip in the Sample Editor, double-click a region icon in the

Media column.

You can use this to set a snap point for a clip, for example. When you later insert the clip

from the Pool into the project, the dened snap point allows it to be properly aligned.