12.0

If you select a region from the list and click this button above, the corresponding section
of the audio clip is selected (as if you had selected it with the Range Selection tool) and
zoomed. This is useful if you want to apply processing to the region only.
6 Play Region
Plays back the selected region.
7 Regions list
Allows you to select and display regions in the audio waveform.
Creating Regions
PREREQUISITE
You have clicked Set up Window Layout on the toolbar, and you have activated Regions.
PROCEDURE
1.
On the Sample Editor toolbar, activate the Range Selection tool.
2.
In the waveform display, select the range that you want to convert into a region.
3.
Perform one of the following actions:
● Above the regions list, click Add Region.
● Select Audio> Advanced> Event or Range as Region.
A region is created, corresponding to the selected range.
4. Optional: Double-click the region name in the list, and enter a new name.
RESULT
The region is added to the regions list.
AFTER COMPLETING THIS TASK
Click the region in the regions list to instantly display it in the Sample Editor.
RELATED LINKS
Creating Regions on page 374
Creating Regions from Hitpoints
You can create regions from hitpoints. This is useful to isolate specic sounds.
PREREQUISITE
The audio event from which you want to create regions is opened in the Sample Editor, and the
hitpoints are set at the correct positions.
PROCEDURE
●
In the Hitpoints section of the Sample Editor Inspector, click Create Regions.
RESULT
Regions are created between two hitpoint positions and shown in the Sample Editor.
Sample Editor
Regions List
362
Cubase AI 12.0.20