12.0

Creating Clips from Selection Ranges
You can create a new clip that contains only the selected range.
PROCEDURE
1. Select a range.
2. Click the selected range, and select Audio> Bounce Selection.
3. Perform one of the following actions:
● Click Replace if you want to replace the original.
● Click No if you want to keep the original.
RESULT
A new Sample Editor window opens with the new clip. It refers to the same audio le as the
original clip, but it contains the audio corresponding to the selection range only.
Regions List
Regions are sections within an audio clip that allow you to mark important sections in the audio.
You can add and edit regions for the selected audio clip in the regions zone.
● To show or hide the Regions, click Set up Window Layout on the toolbar, and activate or
deactivate Regions.
The following controls are available:
1
Region Start
Shows the start of the region in the audio waveform.
2
Region End
Shows the end of the region in the audio waveform.
3
Add Region
Allows you to create a region of the current range selection.
4
Remove Region
Allows you to remove the selected region.
5
Select Region
Sample Editor
Regions List
361
Cubase AI 12.0.20