12.0

Table Of Contents

Length

Species the length of the crossfade area. Cubase tries to center the crossfade, that is,

the length change is applied equally to both sides. To be able to resize a crossfade, it

must be possible to resize the corresponding event. For example, if the fade-out event

already plays its audio clip to the end, its end point cannot be moved any further to the

right.

Equal Gain

Adjusts the fade curves so that the summed fade-in and fade-out amplitudes are the

same all along the crossfade region. This can be benecial for short crossfades.

Equal Power

Adjusts the fade curves so that the energy (power) of the crossfade is constant all along

the crossfade region.

Equal Power curves have only one editable curve point. You cannot change the curve

shape if this mode is selected.

Volume

Allows you to set the audition level.

Pre-roll and Post-roll

● To start playback before the fade area, activate Use Pre-roll.

● To stop playback after the fade area, activate Use Post-roll.

● To adjust the pre-roll time, use the Pre-roll Amount value eld.

● To adjust the post-roll time, use the Post-roll Amount value eld.

Audition buttons

● To audition the fade-out part of the crossfade, click Play Fade Out.

● To audition the whole crossfade, click Play Crossfade.

● To audition the fade-in part of the crossfade, click Play Fade In.

You can set up key commands for this in the Key Commands dialog.