11.0

Destinations Page
The Destinations page allows you to set up the synchronization outputs, and to determine
which external signals leave the application.
MIDI Clock Destinations
In the MIDI Clock Destinations section, you can select any MIDI ports that you want to output
MIDI clock. Some MIDI devices, such as drum machines, can match their tempo and location to
incoming MIDI clock.
MIDI Clock Preferences
In the MIDI Clock Preferences section, the following options are available:
MIDI Clock Follows Project Position
Ensures that the MIDI clock follows Cubase.
Always Send Start Message
MIDI clock transport commands include start, stop, and continue. Activate this if a MIDI
device does not recognize the continue command.
Send MIDI Clock in Stop Mode
Activate this if a MIDI device needs MIDI clock to run continuously in order to operate
arpeggiators and loop generators.
MIDI Timecode Destinations
In the MIDI Timecode Destinations section, you can specify the MIDI ports to which MTC is
routed.
NOTE
Some MIDI interfaces send MTC over all ports by default. If this is the case, only select one port
of the interface for the MTC.
Synchronization
Project Synchronization Setup Dialog
623
Cubase AI 11.0.0