11.0

Table Of Contents

Length and position values are displayed in the selected ruler display format.

The on/off status of the info line in the Drum Editor window and in the Editor tab in the lower

zone of the Project window are independent of each other.

RELATED LINKS

Editing Note Events on the Info Line on page 486

Drum Editor Inspector

The Drum Editor Inspector is located to the left of the note display. It contains tools and

functions for working with MIDI data.

Quantize

Allows you to access the main quantize parameters. These are identical with the

functions on the Quantize Panel.

Length

Contains length-related options, similar to the Functions submenu of the MIDI menu.

● To change the length of the selected MIDI events or all events of the active part if

no events are selected, use the Scale Length/Scale Legato slider.

At the maximum value the notes reach the beginning of the next note.

● To make the new length settings permanent, click Freeze MIDI Lengths.

● To ne-tune the distance between consecutive notes, use the Overlap slider.

At 0 Ticks, the Scale Length/Scale Legato slider extends each note so that it

reaches the next note exactly. Positive values cause the notes to overlap and

negative values allow you to dene a small gap between the notes.

● To use the Legato function or slider to extend a note until the next selected note,

activate

Extend to Next Selected.

This is identical with activating the Legato Mode: Between Selected Notes Only

option in the Preferences dialog.

Setup

Allows you to open a dialog to edit the Drum Editor Inspector settings. Click Setup

Inspector, and from the pop-up menu, select Setup.

NOTE

If you open the Drum Editor in the lower zone, these sections are shown in the Editor Inspector

in the left zone.