11.0

Table Of Contents

Quantize

Allows you to access the main quantize parameters. These are identical with the

functions on the Quantize panel.

Transpose

Allows you to access the main parameters for transposing MIDI events.

Length

Contains length-related options, similar to the Functions submenu of the MIDI menu.

● To change the length of the selected MIDI events or all events of the active part if

no events are selected, use the Scale Length/Scale Legato slider.

At the maximum value the notes reach the beginning of the next note.

●

To make the new length settings permanent, click Freeze MIDI Lengths.

●

To ne-tune the distance between consecutive notes, use the Overlap slider.

At 0 Ticks, the Scale Length/Scale Legato slider extends each note so that it

reaches the next note exactly. Positive values cause the notes to overlap and

negative values allow you to

dene a small gap between the notes.

●

To use the Legato function or slider to extend a note until the next selected note,

activate Extend to Next Selected.

This is identical with activating the Legato Mode: Between Selected Notes Only

option in the Preferences dialog.

Set up Inspector

Allows you to open a dialog to edit the Inspector settings for the editor. Click Set up

Inspector, and from the pop-up menu, select Setup.

NOTE

If you open the Key Editor in the lower zone, these sections are shown in the Editor Inspector in

the left zone.