11.0

Table Of Contents

Record Enabling Tracks on Selection

You can set up a preference so that tracks are record-enabled when you select them.

PROCEDURE

1. Select Edit > Preferences.

2. Open the Editing—Project & MixConsole page and activate Enable Record on Selected

Audio Track or Enable Record on Selected MIDI Track.

RESULT

The tracks are record-enabled when you select them.

Activating Recording Manually

You can activate recording manually.

PROCEDURE

● Do one of the following:

●

Click Record on the Transport panel, on the toolbar, or in the Transport Bar.

● Press Num * .

RESULT

Recording starts from the current cursor position.

NOTE

When you start recording in stop mode, you can start recording from the left locator. For this to

work, you must select Transport > Common Record Modes and activate Start Record at Left

Locator/Punch In Position. The metronome count-in will be applied.

Activating Recording Automatically

Cubase can automatically switch from playback to recording at a given position. This is useful if

you must replace a section of a recording and want to listen to what is already recorded up to the

recording start position.

PROCEDURE

1. Set the left locator to the position where you want to start recording.

2. Activate Punch In on the Transport panel.

3. Activate playback from any position before the left locator.

RESULT

When the project cursor reaches the left locator, recording is automatically activated.