8.0

Included Effect Plug-ins
Modulation Plug-ins
89
Rate
If tempo sync is activated, this is where you specify the base note value for
synchronizing the flanger sweep to the tempo of the host application (1/1 to
1/32, straight, triplet, or dotted).
If tempo sync is deactivated, the sweep rate can be set freely with the Rate
knob.
Sync
Activates/Deactivates tempo sync.
Range Lo/Hi
Set the frequency boundaries for the flanger sweep.
Feedback
Determines the character of the flanger effect. Higher settings produce a
more metallic sounding sweep.
Spatial
Sets the stereo width of the effect. Turn clockwise for a wider stereo effect.
Mix
Sets the level balance between the dry signal and the wet signal. If the effect
is used as a send effect, set this parameter to the maximum value as you can
control the dry/effect balance with the send.
Waveform Shape selector
Allows you to select the modulation waveform, altering the character of the
flanger sweep. A sine and a triangle waveform are available.
Delay
Affects the frequency range of the modulation sweep by adjusting the initial
delay time.
Manual
If this option is activated, the flanger sweep is static, that is, no modulation
takes place.
If the Manual button is deactivated, a knob is available, allowing you to
change the sweep position manually.
Filter Lo/Hi
Allow you to roll off low and high frequencies of the effect signal.
NOTE
If side-chaining is supported, the modulation can also be controlled from another
signal source via the side-chain input. If the side-chain signal exceeds the threshold,
the modulation is controlled by the side-chain signal’s envelope. For a description
of how to set up side-chain routing, see the “Operation Manual”.