8.0

Included Effect Plug-ins
Filter Plug-ins
80
The horizontal axis shows the pattern steps 1 to 16 from left to right, and the vertical
axis determines the (relative) filter cutoff frequency and resonance settings. The
higher up on the vertical axis a step value is entered, the higher the relative filter
cutoff frequency or filter resonance setting.
By starting playback and editing the patterns for the cutoff and resonance
parameters, you can hear how your filter patterns affect the sound source
connected to StepFilter.
Setting Step Values
• To enter a step, click in the pattern grid windows.
• Individual step entries can be dragged up or down the vertical axis, or directly
set by clicking in an empty grid box. By click-dragging left or right,
consecutive step entries are set at the pointer position.
• Change the value for a step by dragging it up or down.
• Draw in a curve by clicking and dragging in the display.
Selecting New Patterns
• Patterns are saved with the project, and up to 8 different cutoff and resonance
patterns can be saved internally. Both the cutoff and resonance settings are
saved together in the 8 pattern slots.
•Use the Pattern Select knob below the Resonance grid to select a new
pattern. New patterns are all set to the same step value by default.
StepFilter Parameters
Base Cutoff
Sets the base filter cutoff frequency. Values set in the Cutoff grid are relative
to the Base Cutoff value.
Base Resonance
Sets the base filter resonance. Values set in the Resonance grid are relative
to the Base Resonance value.
NOTE
Very high Base Resonance settings can produce loud ringing effects at
certain frequencies.
Glide
Applies glide between the pattern steps, causing values to change more
smoothly.
Filter mode
Use this slider to select a filter mode: low-pass, band-pass, or high-pass
(from left to right).