8.0

Included Effect Plug-ins

Delay Plug-ins

Delay

If tempo sync is activated, this sets the base note value for the delay. If tempo

sync is deactivated, the delay time can be set freely in milliseconds.

Sync

Activates/Deactivates tempo sync.

Feedback

Sets the number of repeats for the delay.

Filter Lo

Affects the feedback loop of the effect signal and allows you to roll off low

frequencies. The button below the knob activates/deactivates the filter.

Filter Hi

Affects the feedback loop of the effect signal and allows you to roll off high

frequencies. The button below the knob activates/deactivates the filter.

Mix

Sets the level balance between the dry signal and the wet signal. If the effect

is used as a send effect, set this parameter to the maximum value as you can

control the dry/effect balance with the send.

NOTE

If side-chaining is supported, the delay can also be controlled from another signal

source via the side-chain input. If the side-chain signal exceeds the threshold, the

delay repeats are silenced. If the signal drops below the threshold, the delay repeats

reappear. For a description of how to set up side-chain routing, see the “Operation

Manual”.

PingPongDelay

This is a stereo delay effect that alternates each delay repeat between the left and

right channels. The effect can either be tempo-based or use freely specified delay

time settings.

Cubase

Elements

Cubase

Artist

Cubase

Pro

Nuendo NEK

Included with ––XXXX–

Side-chain

support

–––XXX–