8.0

Included Effect Plug-ins

EQ Plug-ins

Q-Factor

Controls the width, or resonance, of the corresponding band.

Filter mode

For the low and high band, you can choose between three types of shelving

filters, a peak filter (band-pass), and a cut filter (lowpass/high-pass). If Cut

mode is selected, the Gain parameter is fixed.

• Shelf I adds resonance in the opposite gain direction slightly above the

set frequency.

• Shelf II adds resonance in the gain direction at the set frequency.

• Shelf III is a combination of Shelf I and II.

Output (-24 to +24 dB)

This knob on the top right of the plug-in panel allows you to adjust the overall

output level.

Auto Gain

If this button is activated, the gain is automatically adjusted, keeping the

output level constant regardless of the EQ settings.

Spectrum

Shows the spectrum before and after filtering.

Reset

Resets the EQ settings.

Making Settings

PROCEDURE

1. Click the corresponding On/Off button on the left of the plug-in panel to

activate any or all of the 4 equalizer bands (Low, Mid 1, Mid 2, and High).

If a band is activated, the corresponding EQ point appears in the EQ curve display.

2. Set the parameters for an activated EQ band.

This can be done in several ways:

• By using the knobs.

• By clicking on the numeric values and entering new values.

• By dragging points in the EQ curve display.

Using Modifier Keys

When using the mouse to change the parameter settings, modifier keys can be

used. When no modifier key is pressed and you drag an EQ point in the display, the

Gain and Frequency parameters are adjusted simultaneously.