8.0

Included Effect Plug-ins

EQ Plug-ins

Equalizer – Group Editing

You can perform editing operations on a group of control points.

• To select several control points, click inside the equalizer control surface and

drag a rectangle over the control points that you want to select.

• To select all control points at once, right-click the control surface.

• To deselect any selected points, click in the control surface.

• To add control points to the current selection, press [Shift]and click the

control points that you want to add.

• To remove control points from the selection, hold [Shift] and click the control

point that you want to remove.

For group editing, the following controls are available:

Up/down arrow button

Allows you to change the relationship of the selected control points.

Inv

Inverts the gain of the selected control points.

Reset

Resets the current filter to its default state.

Equalizer - Spectrum

The equalizer control surface can display the Fourier spectrum analysis plot. The

spectrum analysis and the display of parameters can be selected via the Mode

selector. The Spectrum Mode Editor can be used to customize these parameters

further. You can also click the control surface anywhere to reset the spectrum

analysis display.

A red vertical line is displayed if the visible frequency range is wide. This line shows

the maximum frequency of the input signal and depends on the input sample rate.

By default, Voxengo plug-ins use a slope value of 4.5 dB per octave for the

spectrum display. This setting can be changed in the Spectrum Mode Editor

window.

To zoom in on the spectrum’s peak values, [Alt]/[Option]-click and drag a selection

rectangle.

If the spectrum does not fit the display, adjust the visible spectrum range in the

Spectrum Mode Editor.