8.0

Included Effect Plug-ins

Dynamics Plug-ins

The window is divided into three sections, containing controls and meters for each

processor. Activate the individual processors using the buttons Gate,

Compressor, and Limiter at the bottom of the plug-in panel.

Gate Section

Gating, or noise gating, is a method of dynamic processing that silences audio

signals below a set threshold. As soon as the signal level exceeds the threshold, the

gate opens to let the signal through. The Gate trigger input can also be filtered

using an internal side-chain signal.

The following parameters are available:

Threshold (-60 to 0 dB)

Determines the level where the gate is activated. Signal levels above the set

threshold trigger the gate to open, and signal levels below the set threshold

close the gate.

State LED

Indicates whether the gate is open (LED lights up in green), closed (LED

lights up in red) or in an intermediate state (LED lights up in yellow).

Side-Chain

Activates the internal side-chain filter. The input signal can then be shaped

according to the filter parameters. Internal side-chaining is useful for tailoring

how the gate operates.

Filter buttons (LP, BP, and HP)

If the Side-Chain button is activated, you can use these buttons to set the

filter type to low-pass, band-pass, or high-pass.

Center (50 to 20000 Hz)

If the Side-Chain button is activated, this sets the center frequency of the

filter.

Q-Factor

If the Side-Chain button is activated, this sets the resonance or width of the

filter.

Cubase

Elements

Cubase

Artist

Cubase

Pro

Nuendo NEK

Included with XXXXXX–