8.0

Included Effect Plug-ins

Dynamics Plug-ins

Threshold (-60 to 0 dB)

Determines the level where the gate is activated. Signal levels above the set

threshold trigger the gate to open, and signal levels below the set threshold

close the gate.

State LED

Indicates whether the gate is open (LED lights up in green), closed (LED

lights up in red) or in an intermediate state (LED lights up in yellow).

Filter buttons (LP, BP, and HP)

If the Side-Chain button is activated, you can use these buttons to set the

filter type to low-pass, band-pass, or high-pass.

Side-Chain

Activates the internal side-chain filter. The input signal can then be shaped

according to the filter parameters. Internal side-chaining is useful for tailoring

how the gate operates.

Center (50 to 20000 Hz)

If the Side-Chain button is activated, this sets the center frequency of the

filter.

Q-Factor

If the Side-Chain button is activated, this sets the resonance or width of the

filter.

Monitor

Allows you to monitor the filtered signal.

Attack (0.1 to 1000 ms)

Sets the time after which the gate opens when it is triggered.

NOTE

Deactivate the Live button to make sure that the gate is already open when a

signal above the threshold is played back.

Hold (0 to 2000 ms)

Determines how long the gate remains open after the signal drops below the

threshold level.