8.0

Included Effect Plug-ins
Distortion Plug-ins
30
Attack – Determines how quickly an effect reacts to the input signal.
Mix – Sets the level balance between the dry signal and the wet signal.
Type – Sets the filter type.
Release – Determines how quickly the effect fades after the input signal
stops.
Volume
Pedal – Controls the level of the signal passing through the effect.
Compressor
Intensity – Sets the amount by which an input signal is being compressed.
Compressor MB
Lo Intensity – Sets the compressor effect in the low frequency band.
Activate/deactivate Auto Makeup Mode by clicking the LED at the top right
of the knob.
Hi Intensity – Sets the compressor effect in the high frequency band.
Activate/deactivate Auto Makeup Mode by clicking the LED at the top right
of the knob.
Crossover – Determines the crossover frequency between the low frequency
band and the high frequency band.
Output – Sets the output level.
Limiter
Threshold – Determines the maximum output level. Signal levels above the
set threshold are cut off.
Release – Sets the time after which the gain returns to the original level.
Maximizer
Amount – Determines the loudness of the signal.
Chorus
Rate – Allows you to set the sweep rate. This parameter can be synchronized
to the project tempo.
Width – Determines the depth of the chorus effect. Higher settings produce
a more pronounced effect.
Tone – Allows you to attenuate low frequencies.
Mix – Sets the level balance between the dry signal and the wet signal.
Phaser
Rate – Allows you to set the sweep rate. This parameter can be synchronized
to the project tempo.
Width – Determines the width of the modulation effect between higher and
lower frequencies.
Tone – Allows you to attenuate the low frequencies.
Mix – Sets the level balance between the dry signal and the wet signal.