8.0

Included VST Instruments
Spector
260
Modulation
You can choose between 3 basic modulation characteristics:
• Phaser uses an 8-pole all-pass filter to produce the classic phasing effect.
• Flanger is composed of two independent delay lines with feedback for the left
and the right channel. The delay time of both delays is modulated by one LFO
with adjustable frequency.
• Chorus produces a rich chorus effect with 4 delays modulated by four
independent LFOs.
Song Sync
Activates/Deactivates tempo sync of the Rate parameter.
Rate
Sets the rate of the LFOs modulating the delay time. If Song Sync is
activated, the rate is synchronized to various beat increments.
Depth
Controls the depth of the delay time modulation.
Delay
Sets the delay time of the four delay lines.
Feedback
Controls the amount of positive or negative feedback for all four delay lines.
Level
Controls the output level of the effect.
SR Parameters
With these buttons, you can change the sample rate. Lower sample rates basically
reduce the high frequency content and sound quality, but the pitch is not altered.
This is useful to emulate the lo-fi sounds of older digital synths.
•If the F button is active, the program of the selected part plays back with the
sample rate set in the host application.
•If the 1/2 button is active, the program of the selected part plays back with
half the original sample rate.
•If the 1/4 button is active, the program of the selected part plays back with a
quarter of the original sample rate.
A bonus effect of using lower sample rates is that it reduces the load on the
computer CPU, allowing for more simultaneous voices to be played, etc.