8.0

Included VST Instruments
Spector
259
• Tape Emulation produces distortion similar to magnetic tape saturation.
• Tube Emulation produces distortion similar to valve amplifiers.
Drive
Sets the amount of distortion by amplifying the input signal.
Filter
Sets the crossover frequency of the distortion filter. The distortion filter
consists of a low-pass filter and a high-pass filter with a cutoff frequency
equal to the crossover frequency.
Tone
Controls the relative amount of low-pass and high-pass filtered signal.
Level
Controls the output level of the effect.
Delay
You can choose between 3 basic delay characteristics:
• Stereo Delay has two separate delay lines panned left and right.
•In Mono Delay, the two delay lines are connected in series for monophonic
dual tap delay effects.
•In Cross Delay, the delayed sound bounces between the stereo channels.
Song Sync
Activates/Deactivates tempo sync of the delay times.
Delay 1
Sets the delay time ranging from 0 ms to 728 ms. If MIDI sync is activated,
the range is from 1/32 to 1/1; straight, triplet or dotted.
Delay 2
Same as Delay 1.
Feedback
Controls the decay of the delays. With higher settings, the echoes repeat
longer.
Filter
A low-pass filter is built into the feedback loop of the delay. This parameter
controls the cutoff frequency of this feedback filter. Low settings result in
successive echoes sounding darker.
Level
Controls the output level of the effect.