8.0

Included VST Instruments
Spector
258
Assign a Controller to a Parameter
PROCEDURE
1. Click in the Mod Dest box for one of the controllers.
A pop-up menu appears in which all possible modulation destinations are shown. All
Sound parameters as well as most LFO and Envelope parameters are available as
destinations.
2. Select a destination.
The selected modulation destination is now shown in the list. Beside the destination,
a default value (50) has been set. The value represents the modulation amount when
the controller is at its full range.
• You can set positive and negative modulation values by clicking on the value in
the list, typing in a new value, and pressing [Enter].
To enter negative values, type a minus sign followed by the value.
3. Using the same basic method, you can add any number of modulation
destinations for the controllers.
They are all listed in the Mod Dest box for each controller.
• To remove a modulation destination, click on its name in the list and select Off
from the pop-up menu.
Effects (EFX) Page
This page features three separate effect units: Distortion, Delay, and Modulation
(Phaser/Flanger/Chorus). The Effect page is opened by clicking the EFX button at
the top of the lower half of the control panel.
• Each separate effect section is laid out with a row of buttons that determine
the effect type or characteristic and a row of sliders for making parameter
settings.
• To activate an effect, click the Active button so that a dot appears.
Clicking again deactivates the effect.
Distortion
You can choose between 4 basic distortion characteristics:
• Distortion provides hard clipping distortion.
• Soft Distortion provides soft clipping distortion.