8.0

Included VST Instruments
Prologue
244
• To remove a modulation destination, click on its name in the list and select Off
from the pop-up menu.
Effects (EFX) Page
This page features three separate effect units: Distortion, Delay, and Modulation
(Phaser/Flanger/Chorus). The Effect page is opened by clicking the EFX button at
the top of the lower half of the control panel.
• Each separate effect section is laid out with a row of buttons that determine
the effect type or characteristic and a row of sliders for making parameter
settings.
• To activate an effect, click the Active button so that a dot appears.
Clicking again deactivates the effect.
Distortion
You can choose between 4 basic distortion characteristics:
• Distortion provides hard clipping distortion.
• Soft Distortion provides soft clipping distortion.
• Tape Emulation produces distortion similar to magnetic tape saturation.
• Tube Emulation produces distortion similar to valve amplifiers.
Drive
Sets the amount of distortion by amplifying the input signal.
Filter
Sets the crossover frequency of the distortion filter. The distortion filter
consists of a low-pass filter and a high-pass filter with a cutoff frequency
equal to the crossover frequency.
Tone
Controls the relative amount of low-pass and high-pass filtered signal.
Level
Controls the output level of the effect.