8.0

MIDI Effects
StepDesigner
189
• The display spans one octave (as indicated by the pitch list to the left). You can
scroll the displayed octave up or down by clicking in the pitch list and dragging
up or down.
This way you can insert notes at any pitch.
• To remove a note from the pattern, click on it again.
NOTE
Each step can contain one note only – StepDesigner is monophonic.
RESULT
If you now start playback in your host application, the pattern plays as well, sending
out MIDI notes on the track’s MIDI output and channel (or, if you activated
StepDesigner as a send effect, on the MIDI output and channel selected for the
send in the Inspector).
Adding Controller Curves
PROCEDURE
1. Open the Controller pop-up menu and select a controller.
The selection is displayed in the lower controller display.
2. Click in the controller display to draw events.
The MIDI controller events are sent out during playback along with the notes.
NOTE
If you drag a controller event bar all the way down, no controller value is sent out on
that step.