8.0

Included Effect Plug-ins
Tools Plug-ins
152
Mode A/Mode B
If the channel mode Surround is selected, these buttons allow you to switch
between different view modes.
Amplitude
Allows you to increase/decrease the vertical size of the waveform.
Frequency
Allows you to select the frequency area for viewing.
SMPTEGenerator
This plug-in is not a real audio effect. It sends out SMPTE timecode to an audio
output, allowing you to synchronize other equipment to your host application
(provided that the equipment can synchronize directly to SMPTE timecode). This
can be very useful if you do not have access to a MIDI-to-timecode converter.
Main timecode display
This display shows the current timecode.
If Link to Transport is deactivated, the generator is in free run mode. You can
use the timecode display to set the SMPTE start time.
If Link to Transport is activated, you cannot change any of the values. This
display shows the current timecode in sync with the Transport panel. Where
applicable, the offset defined in the offset timecode display is taken into
account.
Frame rate display and pop-up menu
The frame rate shown to the right of the timecode display corresponds to the
frame rate set in the Project Setup dialog. To generate timecode in a different
frame rate (for example, to stripe a tape), select another format on the pop-up
menu (only available if Link to Transport is deactivated).
NOTE
For another device to synchronize correctly to your host, the same frame rate
has to be set in the Project Setup dialog, the SMPTE Generator, and the
receiving device.
Cubase
LE
Cubase
AI
Cubase
Elements
Cubase
Artist
Cubase
Pro
Nuendo NEK
Included with ––––XX–