8.0

Included Effect Plug-ins
Spatial + Panner Plug-ins
135
EQ Cutoff
Sets the cutoff frequency of the distance-dependent EQ.
Upmix – Matrix
Activates matrix decoding for matrix-encoded input signals.
NOTE
Matrix decoding is only applied in upmix mode.
LFE Parameters
LFE Gain
Sets a separate gain level for the LFE channel that is applied to the plug-in
output.
LP Enable
Enables a low-pass filter that is applied to the LFE output channel after
summing the signals from the input channels.
LP Cutoff
Sets the cutoff frequency for the generated LFE channel.
LP Order
Allows you to select the order, or slope, of the low-pass filter.
• 2nd order = 12 dB/octave
• 3rd order = 18 dB/octave
• 4th order = 24 dB/octave
NOTE
The amount of LFE can be adjusted for each input channel individually.
NOTE
If the selected input configuration includes an LFE channel, but the selected output
configuration does not, the LFE input channel is distributed to front left and front
right at a level of -3 dB automatically. The low-pass filter is applied to the incoming
LFE signal before it is distributed to the front speakers.
MonoToStereo
This effect turns a mono signal into a pseudo-stereo signal. The plug-in can be used
on a mono file or a stereo file with equal channels.