8.0

Included Effect Plug-ins
Reverb Plug-ins
116
Trim
This slider allows you to trim the start and end of the impulse response. Drag
the front handle to trim the start of the impulse response, and the end handle
to trim the reverb tail.
NOTE
The impulse response is cut without any fading.
EQ Settings
In the Equalizer section, you can tune the sound of the reverb.
EQ curve
Shows the EQ curve. You can use the EQ parameters below the display to
change the EQ curve, or modify the curve manually by dragging the curve
points.
Activate EQ
This button to the right of the EQ parameters activates the EQ for the effect
plug-in.
Low Shelf On
Activates the low shelf filter that boosts or attenuates frequencies below the
cutoff frequency by the specified amount.
Low Freq (20 to 500)
Sets the frequency of the low band.
Low Gain (-24 to +24)
Sets the amount of attenuation/boost for the low band.
Mid Peak On
Activates the mid peak filter that creates a peak or notch in the frequency
response.