8.0

Included Effect Plug-ins
Reverb Plug-ins
115
ER Tail Split
Sets a split point between the early reflections and the tail, allowing you to
determine where the reverb tail begins. A value of 60 means that the early
reflections are heard for 60
ms.
ER Tail Mix
Allows you to set up the relation of early reflections and tail. Values above 50
attenuate the early reflections and values below 50 attenuate the tail.
The Impulse Response Display
The display section allows you to view the impulse response details and to change
the length of the response.
Play
When clicking this button to apply the loaded impulse response, a short click
is played. This provides a neutral test sound that makes it easier for you to
know how different settings influence the reverb characteristics.
Time Scaling
This wheel lets you adjust the reverb time.
Time Domain
This display shows the waveform of the impulse response.
Spectrogram
This display shows the analyzed spectrum of the impulse response. Time is
displayed along the horizontal axis, frequency along the vertical axis, and
volume is represented by the color.
Information
This display shows additional information, such as the name of the program
and the loaded impulse response, the number of channels, the length, and
Broadcast Wave File information.
Activate Impulse Trimming
Use this button at the bottom right of the impulse display section to activate
impulse trimming. The Trim slider is shown below the Impulse display.