8.0

Included Effect Plug-ins
Distortion Plug-ins
10
Delay
If tempo sync is activated, this sets the base note value for the delay. If tempo
sync is deactivated, the delay time can be set freely in milliseconds.
Sync
Activates/Deactivates tempo sync for the corresponding delay.
Feedback
Set the number of repeats for each delay.
Filter Lo
Affects the feedback loop of the effect signal and allows you to roll off low
frequencies. The button below the knob activates/deactivates the filter.
Filter Hi
Affects the feedback loop of the effect signal and allows you to roll off high
frequencies. The button below the knob activates/deactivates the filter.
Pan
Set the stereo position for each delay.
Mix
Sets the level balance between the dry signal and the wet signal. If the effect
is used as a send effect, set this parameter to the maximum value as you can
control the dry/effect balance with the send.
NOTE
If side-chaining is supported, the delay can also be controlled from another signal
source via the side-chain input. If the side-chain signal exceeds the threshold, the
delay repeats are silenced. If the signal drops below the threshold, the delay repeats
reappear. For a description of how to set up side-chain routing, see the “Operation
Manual”.
Distortion Plug-ins
AmpSimulator
AmpSimulator is a distortion effect that emulates the sound of various types of
guitar amp and speaker cabinet combinations. A wide selection of amp and cabinet
models is available.