12.0

Output
Sets the output level.
Phaser
Phaser produces the well-known swooshing phasing effect with additional stereo enhancement.
Feedback
Determines the character of the phaser effect. Higher settings produce a more
pronounced effect.
Width
Sets the intensity of the modulation effect between higher and lower frequencies.
Mode
Allows you to toggle between LFO and Manual mode.
In LFO mode, you can dene the sweep rate or sync it to the project tempo. In Manual
mode, you can change the sweep manually.
Rate
If Tempo Sync is activated, Rate allows you to specify the base note value for tempo-
syncing the phaser sweep (1/1 to 1/32, straight, triplet, or dotted).
If Tempo Sync is deactivated, the sweep rate can be set freely with the Rate dial.
Sync
Activates/Deactivates tempo sync.
Spatial
If you are using multi-channel audio, the Spatial parameter creates a 3-dimensional
impression by delaying modulation in each channel.
Mix
Sets the level balance between the dry signal and the wet signal. If the effect is used
as a send effect, set this parameter to the maximum value, as you can control the
dry/effect balance with the send level.
Lo Filter/Hi Filter
Allow you to roll off low and high frequencies of the effect signal.
Included VST Audio Effect Plug-ins
Modulation Plug-ins
26
Cubase AI 12.0.0