12.0

Flanger
This is a classic anger effect with added stereo enhancement.
Delay
Affects the frequency range of the modulation sweep by adjusting the initial delay
time.
Feedback
Determines the character of the anger effect. Higher settings produce a more
metallic-sounding sweep.
Mode
Allows you to toggle between LFO and Manual mode.
In LFO mode, you can dene the sweep rate or sync it to the project tempo. In Manual
mode, you can change the sweep manually.
Rate
If Tempo Sync is activated, Rate allows you to specify the base note value for
synchronizing the anger sweep to the tempo of the host application (1/1 to 1/32,
straight, triplet, or dotted).
If Tempo Sync is deactivated, the sweep rate can be set freely with the Rate dial.
Sync
Activates/Deactivates tempo sync.
Spatial
Sets the stereo width of the effect. Turn clockwise for a wider stereo effect.
Mix
Sets the level balance between the dry signal and the wet signal. If the effect is used
as a send effect, set this parameter to the maximum value, as you can control the
dry/effect balance with the send level.
Lo Range/Hi Range
Set the frequency boundaries for the anger sweep.
Waveform Shape
Allows you to select the modulation waveform, altering the character of the anger
sweep. A sine and a triangle waveform are available.
Lo Filter/Hi Filter
Allow you to roll off low and high frequencies of the effect signal.
Included VST Audio Effect Plug-ins
Modulation Plug-ins
24
Cubase AI 12.0.0