Plug-in Reference
Table Of Contents
- Table of Contents
- The Included Effect Plug-ins
- MIDI Effects
- The Included VST Instruments
9
The Included Effect Plug-ins
Delay Plug-ins
Ö If side-chaining is supported, the delay can also be controlled from another signal
source via the side-chain input. When the side-chain signal exceeds the threshold,
the delay repeats are silenced. When the signal drops below the threshold, the delay
repeats reappear. For a description of how to set up side-chain routing, see the
Operation Manual.
StereoDelay
StereoDelay has two independent delay lines which either use tempo-based or freely
specified delay time settings.
The following parameters are available:
Spatial Sets the stereo width for the left/right repeats. Turn clockwise for a
more pronounced stereo ping-pong effect.
Mix Sets the level balance between the dry and the wet signal. If
PingPongDelay is used as a send effect, set this to the maximum
value as you can control the dry/effect balance with the send.
Parameter Description
Cubase
LE
Cubase
AI
Cubase
Elements
Cubase
Artist
Cubase Nuendo NEK
Included with
– – – X X X –
Side-chain
support
– – – X X X –
Parameter Description
Delay 1 & 2 If tempo sync is on, this is where you specify the base note value for
the delay (1/1 to 1/32, straight, triplet, or dotted).
If tempo sync is off, the delay time can be set freely in milliseconds.
Sync buttons The buttons below the Delay knobs turn tempo sync on or off for the
corresponding delay.
Feedback 1 & 2 Set the number of repeats for each delay.
Filter Lo 1 & 2 Affect the feedback loop of the effect signal and allow you to roll off
low frequencies up to 800
Hz. The buttons below the knobs
activate/deactivate the filter.
Filter Hi 1 & 2 Affect the feedback loop of the effect signal and allow you to roll off
high frequencies from 20
kHz down to 1.2 kHz. The buttons below the
knobs activate/deactivate the filter.
Pan 1 & 2 Set the stereo position for each delay.
Mix 1 & 2 Set the level balance between the dry and the wet signal. If
StereoDelay is used as a send effect, set these controls to the
maximum value (100
%) as you can control the dry/effect balance
with the send.