Plug-in Reference

Table Of Contents

The Included Effect Plug-ins

Reverb Plug-ins

Making EQ Settings

In the Equalizer section you can tune the sound of the reverb.

The following parameters are available:

Activate Impulse

Trimming button

Use this button at the bottom right of the Impulse display section to

activate impulse trimming. The Trim slider is shown below the Impulse

display.

Trim slider Allows you to trim the start and end of the impulse response. Drag

the front handle to trim the start of the impulse response, or the end

handle to trim the reverb tail. You can also use the mouse wheel for

trimming. Note that the impulse response is cut without any fading.

Parameter Description

EQ curve display Shows the EQ curve. You can use the EQ parameters below the

display to change the EQ curve, or modify the curve manually by

dragging the curve points.

Activate EQ button This button to the right of the EQ parameters activates the EQ for

the effect plug-in.

Low Shelf On button Activates the low shelf filter that boosts or attenuates frequencies

below the cutoff frequency by the specified amount.

Low Freq

(20 to 500)

Sets the frequency of the low band.

Low Gain

(-24 to +24)

Sets the amount of attenuation/boost for the low band.

Mid Peak On button Activates the mid peak filter that creates a peak or notch in the

frequency response.

Mid Freq

(100 to 10000)

Sets the center frequency of the mid band.

Mid Gain

(-12 to +12)

Sets the amount of attenuation/boost for the mid band.

Hi Shelf On button Activates the high shelf filter that boosts or attenuates frequencies

above the cutoff frequency by the specified amount.

Hi Freq

(5000 to 20000)

Sets the frequency of the high band.

Hi Gain

(-24 to +24)

Sets the amount of attenuation/boost for the high band.