Plug-in Reference

ManualsBrandsSteinberg ManualsApplicationsCubase 7.0

Table Of Contents

The Included Effect Plug-ins

Delay Plug-ins

Ö If side-chaining is supported, the delay can also be controlled from another signal

source via the side-chain input. When the side-chain signal exceeds the threshold,

the delay repeats are silenced. When the signal drops below the threshold, the delay

repeats reappear. For a description of how to set up side-chain routing, see the

Operation Manual.

PingPongDelay

This is a stereo delay effect that alternates each delay repeat between the left and

right channels. The effect can either be tempo-based or use freely specified delay

time settings.

The following parameters are available:

Filter Lo Affects the feedback loop of the effect signal and allows you to roll off

low frequencies from 10

Hz up to 800 Hz. The button below the knob

activates/deactivates the filter.

Filter Hi Affects the feedback loop of the effect signal and allows you to roll off

high frequencies from 20

kHz down to 1.2 kHz. The button below the

knob activates/deactivates the filter.

Mix Sets the level balance between the dry and the wet signal. If

MonoDelay is used as a send effect, set this to the maximum value as

you can control the dry/effect balance with the send.

Parameter Description

Cubase

Elements

Cubase

Artist

Cubase Nuendo NEK

Included with

– – X X X X –

Side-chain

support

– – – X X X –

Parameter Description

Delay If tempo sync is on, this is where you specify the base note value for

the delay (1/1 to 1/32, straight, triplet, or dotted).

If tempo sync is off, the delay time can be set freely in milliseconds.

Sync button The button below the Delay knob switches tempo sync on or off.

Feedback Sets the number of repeats for the delay.