Plug-in Reference

76
The Included Effect Plug-ins
Modulation Plug-ins
The following parameters are available:
Directing MIDI to the Rotary
For realtime MIDI control of the Speed parameter, MIDI must be directed to the
Rotary.
• Whenever Rotary has been added as an insert effect (for an audio track or an
FX
channel), it is available on the Output Routing pop-up menu for MIDI tracks.
If Rotary is selected on the Output Routing menu, MIDI is directed to the plug-in
from the selected track.
Parameter Description
Speed selector
(Stop/Slow/Fast)
Allows you to control the speed of the Rotary in three steps.
Speed Change
Mode
Allows you to select whether the Slow/Fast setting is a switch (left)
or a variable control (right). When switch mode is selected and
Pitchbend is the controller, the speed switches with an up or down
flick of the bender. Other controllers switch at MIDI value 64.
Speed Mod When the Slow/Fast setting is set to variable control, this allows you
to select the rotary speed, from 0 (Stop) to 100 (Fast).
MIDI controller
pop-up menu
Allows you to choose the MIDI controller that controls the plug-in.
Set this to “Automation” if you do not want to use MIDI realtime
control.
Overdrive Applies a soft overdrive or distortion.
CrossOver Sets the crossover frequency (200 to 3000 Hz) between the low and
high frequency loudspeakers.
Horn – Slow Allows for a fine adjustment of the high rotor Slow speed.
Horn – Fast Allows for a fine adjustment of the high rotor Fast speed.
Horn – Accel. Allows for a fine adjustment of the high rotor acceleration time.
Horn – Amp Mod Controls the high rotor amplitude modulation.
Horn – Freq Mod Controls the high rotor frequency modulation.
Bass – Slow Allows for a fine adjustment of the low rotor Slow speed.
Bass – Fast Allows for a fine adjustment of the low rotor Fast speed.
Bass – Accel. Allows for a fine adjustment of the low rotor acceleration time.
Bass – Amp Mod Adjusts the modulation depth of the amplitude.
Bass – Level Adjusts the overall bass level.
Microphones –
Phase
Adjusts the phasing amount in the sound of the high rotor.
Microphones –
Angle
Sets the simulated microphone angle. 0 = mono, 180 = a mic on
each side.
Microphones –
Distance
Sets the simulated microphone distance from the speaker in inches.
Output Adjusts the overall output level.
Mix Adjusts the mix between dry and processed signal.