Plug-in Reference

74
The Included Effect Plug-ins
Modulation Plug-ins
Ö If side-chaining is supported, the modulation can also be controlled from another
signal source via the side-chain input. When the side-chain signal exceeds the
threshold, the modulation is controlled by the side-chain signal’s envelope. For a
description of how to set up side-chain routing, see the Operation Manual.
RingModulator
RingModulator can produce complex, bell-like enharmonic sounds. Ring modulators
work by multiplying two audio signals. The ring modulated output contains added
frequencies generated by the sum of, and the difference between, the frequencies of
the two signals.
RingModulator has a built-in oscillator that is multiplied with the input signal to
produce the effect.
The following parameters are available:
Manual button Use this button to activate/deactivate the Manual function. If
activated, the flanger sweep is static, that is, no modulation takes
place.
Filter Lo/Hi Allow you to roll off low and high frequencies of the effect signal.
Parameter Description
Cubase
LE
Cubase
AI
Cubase
Elements
Cubase
Artist
Cubase Nuendo NEK
Included with
– X X X X X –
Parameter Description
Oscillator –
LFO
Amount
Controls how much the oscillator frequency is affected by the LFO.
Oscillator –
Env.
Amount
Controls how much the oscillator frequency is affected by the
envelope (which is triggered by the input signal). Positive and
negative values can be set, with center position representing no
modulation. Left of center, a loud input signal decreases the
oscillator pitch, whereas right of center the oscillator pitch
increases when fed a loud input.
Oscillator –
Waveform buttons
Allows you to select the oscillator waveform; square, sine, saw, or
triangle.
Oscillator –
Range
slider
Determines the frequency range of the oscillator in Hz.