Plug-in Reference

73
The Included Effect Plug-ins
Modulation Plug-ins
Phaser
Phaser produces the well-known swooshing phasing effect with additional stereo
enhancement.
The following parameters are available:
Output slider Sets the overall volume.
Mix slider Sets the level balance between the dry and the wet signal. If Metalizer
is used as a send effect, set this to the maximum value as you can
control the dry/effect balance with the send.
Parameter Description
Cubase
LE
Cubase
AI
Cubase
Elements
Cubase
Artist
Cubase Nuendo NEK
Included with
X X X X X X –
Side-chain
support
– – – X X X –
Parameter Description
Rate If tempo sync is on, this is where you specify the base note value for
tempo-syncing the phaser sweep (1/1 to 1/32, straight, triplet, or
dotted).
If tempo sync is off, the sweep rate can be set freely with the Rate
knob.
Sync button The button below the Rate knob switches tempo sync on or off.
Width Determines the width of the modulation effect between higher and
lower frequencies.
Feedback Determines the character of the phaser effect. Higher settings
produce a more pronounced effect.
Spatial When using multi-channel audio, the Spatial parameter creates a 3-
dimensional impression by delaying modulation in each channel.
Mix Sets the level balance between the dry and the wet signal. If Phaser
is used as a send effect, set this to the maximum level as you can
control the dry/effect balance with the send.
Manual knob Allows you to change the sweep position manually when the Manual
button is deactivated. The value range is from 0 to 100.