Plug-in Reference

72
The Included Effect Plug-ins
Modulation Plug-ins
Ö If side-chaining is supported, the modulation can also be controlled from another
signal source via the side-chain input. When the side-chain signal exceeds the
threshold, the modulation is controlled by the side-chain signal’s envelope. For a
description of how to set up side-chain routing, see the Operation Manual.
Metalizer
Metalizer feeds the audio signal through a variable frequency filter, with tempo sync or
time modulation and feedback control.
The following parameters are available:
Manual knob Allows you to change the sweep position manually when the Manual
button is deactivated. The value range is from 0 to 100.
Manual button Use this button to activate/deactivate the Manual function. If
activated, the flanger sweep is static, that is, no modulation takes
place.
Filter Lo/Hi Allow you to roll off low and high frequencies of the effect signal.
Parameter Description
Cubase
LE
Cubase
AI
Cubase
Elements
Cubase
Artist
Cubase Nuendo NEK
Included with
– X X X X X –
Parameter Description
Feedback The higher the value, the more metallic the sound.
Sharpness Governs the character of the filter effect. The higher the value, the
narrower the affected frequency area, producing a sharper sound and
a more pronounced effect.
Tone Governs the feedback frequency. The effect of this is more noticeable
with high Feedback settings.
On button Turns filter modulation on and off. When turned off, Metalizer works
as a static filter.
Mono button When this is activated, the output of Metalizer is mono.
Speed If tempo sync is on, this is where you specify the base note value for
tempo-syncing the effect (1/1 to 1/32, straight, triplet, or dotted).
Note that there is no note value modifier for this effect.
If tempo sync is off, the modulation speed can be set freely with the
Speed knob.
Sync button The button above the Speed knob switches tempo sync on (button
lights up) or off.