Plug-in Reference

70
The Included Effect Plug-ins
Modulation Plug-ins
Cloner
The Cloner plug-in adds up to four detuned and delayed voices to the signal, for rich
modulation and chorus effects.
The following parameters are available:
Cubase
LE
Cubase
AI
Cubase
Elements
Cubase
Artist
Cubase Nuendo NEK
Included with
– – – – X X –
Parameter Description
Voices Allows you to select the number of voices (up to four). For each
added voice, a Detune and a Delay slider are added in the right half of
the panel.
Spatial Spreads the added voices across the stereo spectrum. Turn
clockwise for a deeper stereo effect.
Mix Sets the level balance between the dry and the wet signal. If Cloner is
used as a send effect, set this to the maximum value as you can
control the dry/effect balance with the send.
Output Allows you to reduce or increase the output gain by up to 12 dB.
Detune slider
1 to 4
Controls the relative detune amount for each voice. Positive and
negative values can be set, from -100 to 100. A value of zero means
no detune for that voice.
Delay slider
1 to 4
Controls the relative delay amount for each voice. A value of zero
means no delay for that voice.
Detune Governs the overall depth of the detuning for all voices. If this is set to
zero, no detuning takes place, regardless of the Detune slider
settings.
Natural button By clicking the Natural button below the Detune knob, you can
change the pitch algorithm.
Detune –
Humanize
Controls the amount of detune variation when Static Detune is
deactivated. With Humanize, the detune is constantly modulated for a
more natural effect. The value range is from 0 to 100 (strongest
detune variation).
Static Detune
button
Use this button to activate/deactivate the Static Detune function. If
activated, the set detune amount is static, and the Humanize knob is
grayed out.
Delay Governs the overall depth of the delay for all voices. If set to zero, no
delay takes place regardless of the Delay slider settings.