Plug-in Reference

Table Of Contents

The Included Effect Plug-ins

Modulation Plug-ins

Chorus

This is a single-stage chorus effect. It works by doubling whatever is sent into it with a

slightly detuned version (see also

“StudioChorus” on page 77).

The following parameters are available:

Ö If side-chaining is supported, the modulation can also be controlled from another

signal source via the side-chain input. When the side-chain signal exceeds the

threshold, the modulation is controlled by the side-chain signal’s envelope. For a

description of how to set up side-chain routing, see the Operation Manual.

Cubase

Elements

Cubase

Artist

Cubase Nuendo NEK

Included with

X X X X X X –

Side-chain

support

– – – X X X –

Parameter Description

Rate If tempo sync is on, this is where you specify the base note value for

tempo-syncing the chorus sweep (1/1 to 1/32, straight, triplet, or

dotted).

If tempo sync is off, the sweep rate can be set freely with the Rate

knob.

Sync button The button below the Rate knob switches tempo sync on or off.

Width Determines the depth of the chorus effect. Higher settings produce a

more pronounced effect.

Waveform Shape

selector

Allows you to select the modulation waveform, altering the character

of the chorus sweep. A sine and a triangle waveform are available.

Spatial Sets the stereo width of the effect. Turn clockwise for a wider stereo

effect.

Mix Sets the level balance between the dry and the wet signal. If Chorus

is used as a send effect, set this to the maximum value as you can

control the dry/effect balance with the send.

Delay Affects the frequency range of the modulation sweep by adjusting the

initial delay time.

Filter Lo/Hi Allow you to roll off low and high frequencies of the effect signal.