Plug-in Reference

Table Of Contents

The Included Effect Plug-ins

EQ Plug-ins

GEQ-10/GEQ-30

These graphic equalizers are identical in every respect except for the number of

available frequency bands (10 and 30, respectively). Each band can be attenuated or

boosted by up to 12

dB, allowing for fine control of the frequency response. In

addition there are several preset modes available which can add color to the sound of

the GEQ-10/GEQ-30.

• You can draw response curves in the main display by click-dragging with the

mouse.

Note that you have to click on one of the sliders first before dragging across the

display. You can also point and click to change individual frequency bands, or

enter values numerically by clicking on a gain value at the top of the display.

• At the bottom of the window the individual frequency bands are shown in Hz.

• At the top of the display the amount of attenuation/boost is shown in dB.

Apart from the frequency bands, the following parameters are available:

About the Filter Modes

On the pop-up menu in the lower right corner there are several different EQ modes

available. These modes can add color or character to the equalized output in various

ways. The following filter modes are available:

Cubase

Elements

Cubase

Artist

Cubase Nuendo NEK

Included with

–/– –/– X/– X/X X/X X/X –/–

Parameter Description

Output Controls the overall gain of the equalizer.

Flatten button Resets all the frequency bands to 0 dB.

Range Allows you to relatively adjust how much a set curve attenuates or

boosts the signal. If the Range parameter is turned fully clockwise,

the range is ±12

dB.

Invert button Inverts the current response curve.

Mode pop-up

The filter mode set here determines how the various frequency band

controls interact to create the response curve, see below.

Filter mode Description

True Resp Applies serial filters with an accurate frequency response.