Plug-in Reference

31
The Included Effect Plug-ins
Dynamics Plug-ins
The following MIDI Gate parameters are available:
Parameter Description
Attack Determines how long it takes for the gate to open after receiving a
signal that triggers it.
Hold Regulates how long the gate remains open after a note-on or note-off
message (see Hold Mode).
Release Determines how long it takes for the gate to close (in addition to the
value set with the Hold parameter).
Note To Attack Determines to which extent the velocity values of the MIDI notes
affect the attack. The higher the value, the more the attack time
increases with high note velocities. Negative values give shorter
attack times with high velocities. If you do not wish to use this
parameter, set it to the 0
position.
Note To Release Determines to which extent the velocity values of the MIDI notes
affect the release. The higher the value, the more the release time
increases. If you do not wish to use this parameter, set it to the
0
position.
Velocity To VCA Controls to which extent the velocity values of the MIDI notes
determine the output volume. At a value of 127 the volume is
controlled entirely by the velocity values, and at a value of 0 the
velocities have no effect on the volume.
Hold Mode Use this switch to set the Hold Mode. In Note-On mode, the gate
only remains open for the time set with the Hold and Release
parameters, regardless of the length of the MIDI note that triggered
the gate. In Note-Off mode, the gate remains open for as long as the
MIDI note plays, and then the Hold and Release parameters are
applied.