Plug-in Reference

193
The Included VST Instruments
Prologue
Modulation and Controllers
The lower half of the control panel displays the various modulation and controller
assignment pages available as well as the effect page. You switch between these
pages using the buttons below the Filter section.
The following pages are available:
• The LFO page has two low frequency oscillators (LFOs) for modulating
parameters.
• The Envelope page contains the four Envelope generators which can be assigned
to control parameters – see
“Envelope Page” on page 195.
• The Event page contains the common MIDI controllers (Mod wheel, Aftertouch,
etc.) and their assignments – see
“Event Page” on page 198.
• The Effect page has three separate effect types available; Distortion, Delay and
Modulation – see
“Effects (EFX) Page” on page 199.
LFO Page
The LFO page is opened by clicking the LFO button at the top of the lower half of the
control panel. The page contains all parameters and the modulation and velocity
destinations for two independent LFOs.
Depending on the currently selected preset, there may already be modulation
destinations assigned, in which case these are listed in the “Mod Dest” box for each
LFO – see
“Assigning LFO Modulation Destinations” on page 194. A low frequency
oscillator (LFO) is used for modulating parameters, for example the pitch of an
oscillator (to produce vibrato), or for any parameter where cyclic modulation is
required.
The two LFOs have identical parameters:
Parameter Description
Speed This governs the rate of the LFO. If the sync mode is set to MIDI, the
available rate values are selectable as note values, for example, beat
increments of the sequencer tempo.
Depth This controls the amount of modulation applied by the LFO. If set to
zero, no modulation is applied.
Waveform This sets the LFO waveform.
Sync mode
(Part/MIDI/Voice/
Key)
This sets the sync mode for the LFO.