Plug-in Reference

16
The Included Effect Plug-ins
Distortion Plug-ins
Limiter Threshold Determines the maximum output level. Signal levels
above the set threshold are cut off.
Release Sets the time after which the gain returns to the original
level.
Maximizer Amount Determines the loudness of the signal.
Chorus Rate Allows you to set the sweep rate.
This parameter can be synchronized to the project
tempo, see
“Sync Mode” on page 18.
Width Determines the depth of the chorus effect. Higher
settings produce a more pronounced effect.
Phaser Rate Allows you to set the sweep rate.
This parameter can be synchronized to the project
tempo, see
“Sync Mode” on page 18.
Width Determines the width of the modulation effect between
higher and lower frequencies.
Flanger Rate Allows you to set the sweep rate.
This parameter can be synchronized to the project
tempo, see
“Sync Mode” on page 18.
Feedback Determines the character of the flanger effect. Higher
settings produce a more metallic sounding sweep.
Mix Sets the level balance between the dry and the wet
signal.
Tremolo Rate Allows you to set the modulation speed.
This parameter can be synchronized to the project
tempo, see
“Sync Mode” on page 18.
Depth Governs the depth of the amplitude modulation.
Octaver Direct Adjusts the mix of the original signal and the generated
voices. A value of 0 means only the generated and
transposed signal is heard. By raising this value, more of
the original signal is heard.
Octave 1 Adjusts the level of the signal that is generated one
octave below the original pitch. A setting of 0 means
that the voice is muted.
Octave 2 Adjusts the level of the signal that is generated two
octaves below the original pitch. A setting of 0 means
that the voice is muted.
Delay Delay Sets the delay time in milliseconds.
This parameter can be synchronized to the project
tempo, see
“Sync Mode” on page 18.
Feedback Sets the number of repeats for the delay.
Mix Sets the level balance between the dry and the wet
signal.
Effect Option Description