Plug-in Reference

158
The Included VST Instruments
Groove Agent ONE
• By default, the parameters of the selected samples are adjusted in relation to their
previous settings. If you want to set a specific value for all selected samples,
[Ctrl]/[Command]-click the quick control to set an initial value, release
[Ctrl]/[Command] and adjust the value.
The parameter is set to the same value for all selected sample pads.
On the Voice, Filter, and Amplifier pages, sample-specific data is displayed:
Depending on the selected page (Play, Voice, Filter, Amplifier), up to six quick
controls with different pad-specific parameter assignments are displayed.
Parameter Description
Brightness slider Use the little slider at the very top of the LCD display to set the
display brightness.
VST Preset The name of a loaded VST preset is displayed in the top left of the
LCD display.
Sample/Pad The name of the sample (and the pad to which it is assigned).
Trash icon You can remove the current sample assignment by clicking on a pad
or on the Layer indicator and dragging it onto the trash icon.
MIDI input off When the MIDI symbol button in the top right corner of the LCD
display is activated, the LCD display shows the waveform and
parameter values of the currently playing sample. When this button is
deactivated, the display shows only the data for the currently edit
selected sample.
Layer indicator The long bar near the top of the LCD display shows the active layer
for the current pad. If more than one layer exist for the selected pad,
the bar is divided accordingly. You can drag the dividing line between
layers to change the velocity ranges of the layers. You can drag a new
sample from the MediaBay and drop it directly onto the Layer
indicator bar (this is the same as dropping a sample on a pad). You
can drag layers to a different position on the bar.
Layer number The layer number indicates which is the active layer of the current
pad.
Sample This is the name of the sample file.
Velocity Here you can specify a velocity range for the current layer.
Coarse Here you can tune the sample by up to ±12 semitones.
Fine This parameter lets you fine-tune the sample by up to ±100 cents.
Volume Sets the sample volume.
Waveform display The waveform of the current sample.
s/e locators in
waveform display
You can define the sample start and end points by dragging the s and
e locators in the waveform display. When you click on a locator and
press [Ctrl], this zooms in on the waveform and centers the display
around the locator. Note that the locators automatically snap to zero
crossings.